Polsilver Super Iridium were my go-to for many years, but I've had to part ways with them because I simply no longer tolerate wax spots on razor blades.
I have found the Kai blades give me similar results to the SIs without the darn wax spots.
Are wax spots even necessary? I would think it would be a production cost savings to the blade makers.
Stepping off the soapbox now...
I have found the Kai blades give me similar results to the SIs without the darn wax spots.
Are wax spots even necessary? I would think it would be a production cost savings to the blade makers.
Stepping off the soapbox now...
(05-22-2018, 07:40 PM)merelymoe Wrote: Are wax spots even necessary? I would think it would be a production cost savings to the blade makers.A very good question, and my thinking is that since some blade manufacturers seem to do just fine without the spots, the answer is probably “no”.
merelymoe, have you found a good source for Kai blades? (That is, if you’re comfortable divulging that information…) They seem to be perhaps the most expensive modern blades available. (Only the ice-treated Timor blades might reside in the same price class.)
Whenever I go to shave, I assume there’s someone else on the planet shaving, so I say “I’m gonna go shave, too.”
– Mitch Hedberg
– Mitch Hedberg
(This post was last modified: 05-22-2018, 10:22 PM by merelymoe.)
Sounds a bit like Gillette over-marketing their product. I'm not saying that shifting wouldn't impact blade edge, but in the tests I've run with blades lacking the wax dots, I haven't noticed any marked difference to those razors I've used with wax dots. In fact, I think the KAI outperform and have a much sharper edge than quite a few of the waxed dot blades I've tried. Just my $.02...
Users browsing this thread: