#1
I wanted to know if on the razors in question we can also use handles that are not Wolfman and Raw. Thank you
#2

Member
Europe
Yes, I sometimes use UFO handles for both

jags009 likes this post
#3
(This post was last modified: 08-11-2019, 02:14 PM by jags009.)
I don't own either but have seen people using different handles. Let others chime in too.


Sent from my iPhone using Tapatalk
#4
Thank you
#5
M5 x 0.8 is this the size of the threads on the Wolfman?
#6
The answer is yes for me. Got a new Tbam handle and was just messing around and pulled a few razors out of my rack to try the handle on and I pulled my WR1 and Raw along with my Ikon Tech and the handle fit all of them. I like the handles that come with each of these 3 razors so I won't change them.

keto likes this post
#7
I would have to concur with Dragonsbeard. I have three Tibam handle and all of them hit my Wolfman WR2 perfectly.

Dragonsbeard likes this post
Henery
#8
You can use any standard threaded handle you wish.

ScientificShaves and JimmyH like this post
#9
Almost every standard handle I own fits the RS10
#10
Yes M5x0.8 is the standard, in other words, they are virtually all interchangeable. However, very occasionally, due to very tight tolerances you may strike one (like I have) where, while the post fits the handle, it won't go through the hole in the baseplate or the hole in the handle is slightly too shallow for the post. So no guarantees but very unlikely you find one that doesn't fit.


Users browsing this thread: