#1
I'm enjoying the Supply razor that arrived recently. But I noticed that only with the medium plate, the one with two dots, will the injector line up with the slot on the head and allow the blade to be injected. When I use the mild head or the aggressive head, the blade hits the plate and won't align with the slot. 

Is this just me or my razor? 

It's not a huge deal. It does mean that when using the other two plates I have to load the blades by hand, which is fiddly but doable.
#2
(This post was last modified: 07-02-2020, 10:17 PM by BBS.)
Try loosening the screw a little bit if it is fully tightened down when loading the blades. If you can't pull the plate forward with your thumb by the guard it has no give to move to accept the blade.

don'tfeartheweeper likes this post
#3
Thanks, will try it.
#4

Merchant
San Diego CA
Is your Supply new? As I recall, the early razors had some issues using the injector mechanism. Mine works fine, but I believe this was an issue they addressed at some point.

don'tfeartheweeper likes this post
#5
Good question. It should be, I bought it in May. Will check with them.

Thanks.
#6

Merchant
San Diego CA
(07-02-2020, 11:49 PM)don\tfeartheweeper Wrote: Good question. It should be, I bought it in May. Will check with them.

Thanks.

Oh yea that's far beyond the early issues. I'm talking on the order of four years ago so that's not it.


Users browsing this thread: 1 Guest(s)