#1
[Image: Nqji3aO.jpg][Image: jSv1gjB.jpg][Image: Onuop6Y.jpg]
Just got into this craze about 6 months ago and no looking back. Luckily the wife is tolerant about my strange obsessions. I'm planning to insert clear PVC tubing into the razor holder with the larger holes as some of my razor handles were getting a tad scratched near the base, putting them into the holder with the smaller holes. Two of the brush slots need widening so the brushes  can slide in easier. Another couple of weeks and it should be just fine. Meanwhile, just received my razor from H&S, the 17-4 SB and it is beautifully machined. Haven't tried it yet. Surprised there is no lettering on there indicating the stainless steel used or where its made but it is beautiful to look at.

Marko, ALI and Rebus Knebus like this post
#2
Like the brush and razor holders. Where did you get them from?


Sent from my iPhone using Tapatalk
#3
Thanks. Had a local machinist make them for me, here in California, from some brass stock he had. I gave him the design I wanted and the dimensions. The razor holders are a solid block of brass but the brush holders are 3 plates screwed together. They still need a little bit of work to get them to where I want but it does the job for now. They're heavy and sit solid on the counter.

jags009 likes this post


Users browsing this thread: 1 Guest(s)