Help!! New badger knot in handle

Hey guys .

I dont think i put enough epoxy to the brush . any sugestion? If the knot comes out can i re glue it ?

Epoxy is a very strong adhesive. A tiny dab would be enough to hold a shaving brush knot in so I doubt you used too little. If it does come out you can just reglue it. Be sure to scrape any old dried up glue from the surfaces though.

Pics? The easy answer is sure, you can reglue. Rough up surfaces with sandpaper and get the brush back into service.

I cant post pics in here . Only appears a code not an image idont know why .
But is a maggard 24 2 band knot in a razorock clear and black handle

If it comes back out easily, redoing it is doable...

Pics?  The easy answer is sure, you can reglue.  Rough up surfaces with sandpaper and get the brush back into service.

+1. The plugs at the bases of many knots are very slick; so there's little for an adhesive to grab onto. Roughing the base of the knot with some medium grit (~150-220) sandpaper will solve that problem. A small dab of slow curing epoxy will secure the knot 'til the end of time.

As stated already, you should be fine. Even a drop of silicone is sufficient. If it falls out, sand and re-glue!

Hey so far so good!!